The AD8015 is a wide bandwidth, single supply transimpedance amplifier optimized for use in a fiber optic receiver circuit. It is a complete, single chip solution for converting photodiode current into a differential voltage output. The 240 MHz bandwidth enables AD8015 application in FDDI receivers and SONET/SDH receiv The AD8015 Transimpedance Amplifier Module.
Read More
Power Consumption: TIAs should have low power consumption, which is proportional to the amplifier's quiescent current in the unloaded state. Low values of quiescent current are preferred so that the device will not leak excessive power. Transimpedance amplifiers (TIAs) act as front-end amplifiers for optical sensors such as photodiodes, converting the sensor's output current to a voltage.
Read More
The device computes the logarithm or log-ratio of an input current or voltage relative to a reference current or voltage (logarithmic transimpedance amplifier). High precision is verified over a wide dynamic range of input signals on either bipolar (±5V) or single (5V) supply. The amplifier was used both to measure pixel currents in an imager as well as currents from a floating gate array for accurate programming. The OPA380 far exceeds the offset, drift, and noise performance that conventional JFET op amps provide.
Read More
The linear channel in optical receivers consists of a high-gain amplifier (the main amplifier) and a low-pass filter. In-line amplifiers: Periodically amplify signal due to fiber attenuation, high G, high Psat. Optical modules are devices used to connect network devices, transmit and receive data between network devices, and can be used to convert optical and electrical signals. In the intensity-modulation/direct-detection (IM-DD) system, the intensity modula-tion means that information is carried only by the intensity or power of the transmitted lightwave, not by its frequency or phase.
Read More
The operational transconductance amplifier (OTA) is an amplifier that outputs a current proportional to its input voltage. However, these devices serve a very useful function that is being implemented on a regular basis in many integrated circuits as an element for more advanced purposes; the current feedback. This means that an external controlling signal, either a current or a voltage, will be used to set a key parameter of the circuit, such as closed-loop gain or f 2.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain