An optical transistor, also known as photonic transistor, optical switch or light valve, is a device that switches or amplifies. Since the input signal intensity may be weaker than that of the source, an optical transistor amplifies the optical signal.
Read More
An armored optical cable is a type of fiber optic cable reinforced with a protective layer—usually corrugated steel tape (STA) or steel wires (SWA) —to shield the internal fibers from external threats such as crushing, rodent bites, moisture, and harsh installation conditions. With a durable protective layer, they are ideal for harsh or high-traffic environments. Executive Summary: Both armored and unarmored fiber optic cables transmit light signals at near-speed-of-light speeds. But when it comes to protecting your fiber optic network from rodents, construction damage, and harsh weather, the difference between these two cable types can mean the difference.
Read More
Lines or ropes must be placed using care, where there are already optical fibre cables in a duct; knots in the lines or ropes must be avoided. Fiber optic cables have Kevlar aramid yarn or a fiberglass rod as their strength member. They are designed to withstand heavy loads and stresses, making them ideal for applications where safety and reliability are paramount. Where reels are supplied with protective material fitted over the cable, the protection should remain in place until the cable will be installed.
Read More
Taking the Huawei 5700 series switches as an example, the commands to view optical module information are as follows: Transceiver Type :1000_BASE_SX_SFP Connector Type :LC Wavelength(nm) :850 Transfer Distance(m) :300(50um),150(62. 5um)When the optical module on an interface is faulty, you can run the display commands to view information about the optical module. For inquiries about our products or pricelist, please leave your information with us and we will be in touch with in 24 hours.
Read More
First, check the basics—look for power issues on your optical network terminal and inspect all cables for visible damage. Many fiber internet problems come from dirty connectors or loose plugs, not major faults. Understanding the causes and types of fiber optic cable damage helps detect issues early and determine when repair is needed. Whether you're a network engineer, IT manager, or service provider, understanding these challenges and how to address them is critical for maintaining high-performance, reliable. A common one is an improperly connected or loosely engaged connector, which can be difficult to spot in a crowded patch panel. Connector quality itself may also be at fault, particularly if end-face geometry doesn't meet the IEC PAS 61755-3 standards.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain