In computer networking, Gigabit Ethernet (GbE or 1 GigE) is the transmission of Ethernet frames at a rate of a gigabit per second. History was the result of research conducted at in the early 1970s, and later evolved into a widely implemented and protocol.
Read More
Insufficient Power Delivery Devices (like IP cameras or access points) not powering up. Power over Ethernet (PoE) is a convenient technology that enables network cables to carry electrical power, eliminating the need for additional wiring. In a basic PoE power supply system, the major components are the power sourcing equipment (PSE), the powered device (PD), and the PoE cables. However, When I checked interface status using 'show int status', It looks 'notconnect' status.
Read More
Connect any of the "LAN" ports on the first router to a port in the switch. TL;DR: Is there a way to have two different (unreliable) ISPs connected to a single network switch, so that when one drops out, the home network is automatically switched to the other ISP? --- Hi all! I am a networking hobbyist, and I built out a home network for a family friend of mine living in. In computer communications, a Local Area Network (LAN) can have multiple connections to external Internet Service Providers. This is typically done for fault tolerance--if one link falls, the LAN is still connected to the outside world through the other link--and for increased bandwidth.
Read More
At home I have the following setup - a tp-link switch modem connected to the internet and 2 routers (both AX53 3000), connected to that switch. I want to set them up in such a way that both belong to the same network (Wi-Fi SSID too) and both have access to the internet. We have 2 internet connections coming in to our building - neither are great (2 different routers from different providers). Are there technologies in Network Switches to support active switching or load balancing across the two connections? I know this maybe standard but I am not familiar with the. When configuring the router, I ran into the following problem: I can't define the same default gateway on both interfaces of the router that connect to the switches (as far as i know).
Read More
Short answer: as long as your ethernet cables are able to match or exceed the speed of your fiber connection, then probably not worth it. Something like Router -> RJ-45 cable -> RJ-45 to Fiber -> Fiber cable through the wall -> Fiber to RJ-45 -> RJ-45 cable -> computer (or eventually a switch). Does that even exist ? I have googled a bit but fiber is so complex and has so many variants it is hard to find scenarios similar to mine. If you wired things up using two pairs per device back in 100BASE-T days, however, you'll want to redo your cabling before you buy new switches. Fiber optic technology is a method of transmitting information from one point to another using light signals that are transmitted along thin, flexible fibers made of glass or plastic. It has become an essential component of our daily lives, providing fast and reliable communication over long. Despite the impressive capabilities of fiber optics, copper Ethernet cables remain indispensable for several reasons: Power and Data Transmission: Copper cables transfer data via electrical signals and deliver power through technologies like Power over Ethernet (PoE). There are different types of both, offering different features and they're designed with different use cases in mind, so doing a direct fiber optic cables vs.
Read More+34 910 257 483
Calle de la Innovación 22, 28043 Madrid, Spain