SUBSTATION LIGHTING TECHNICAL SPECIFICATION

What SPD specification should be selected for the lighting distribution box

What SPD specification should be selected for the lighting distribution box

For lighting distribution applications, the SPD should be selected with a nominal discharge current In and maximum discharge current Imax suitable for the exposure level, while the voltage protection level Up must remain below the impulse withstand capability of the protected. Surge Protection Devices (SPD) in a Lighting Distribution Board are essential for preserving lamp circuits, LED drivers, contactors, dimming modules, timers, photoelectric relays, and networked lighting controls from transient overvoltages caused by lightning, utility switching, or large motor. If your company is operating with unprotected electrical infrastructure, your systems are exposed to the potentially catastrophic effects of lightning and surge events. Section 443 of BS 7671:2018+A2:2022 contains requirements for protection against transient overvoltages either of atmospheric origin or due to switching.

Read More
Technical Requirements for Optical Cable Quality Standards

Technical Requirements for Optical Cable Quality Standards

IEC Technical Committee (TC) 86—which prepares standards for fiber-optic systems, modules, devices and components—includes three main subcommittees: SC 86A (Fibers and Cables), SC 86B (Interconnecting Devices and Passive Components) and SC 86C (Systems and Active Devices). This work materialized through the development of good practices, procedures and specifications documents, reflecting a certain state of the art at a given time, and the result of a consensus of all stakeholders (op lable. Supplement 47 to ITU-T G-series Recommendations provides information on the general transmission characteristics of single-mode optical fibres and cables specified in the ITU-T G. We offer full-service OEM and ODM solutions for fiber optic cables, assemblies, and connectivity products — from design and prototyping to global production and logistics.

Read More
Technical briefing on platform cable tray supports

Technical briefing on platform cable tray supports

The International Electrotechnical Commission (IEC) provides detailed guidelines for cable tray systems under IEC 61537. This standard outlines the construction requirements, testing methods, and performance parameters for cable trays and related support systems. When developing our cable support OBO can offer reliable solutions for systems, three attributes are at the routing and fastening cables securely core of what we do: efficiency, resil- for each of these installation challeng-ience and safety. maintain spacing or to keep cables in place when the tray is ect the minimum bend ra-dius for cables as they exit the bottom of the cable tray. A rung spacing of 6 to 9 inches (150 to 230 mm) is preferable when the cable tray cont d for instrumentation and control applications that require. The mechanical and electrical characteristics, tests, certifications, overall quality management, recommendations mentioned. Using cable trays in the recognised OBO quality means that all the requirements for electrical installa-tions on the construction site can be mastered profes-sionally and safely.

Read More
Gyfty Optical Cable Technical Parameters

Gyfty Optical Cable Technical Parameters

GYFTY Non-armored Stranded Loose Tube Cable features FRP as the central member, ensuring the resistance to electromagnetic interference. The water-blocking material between a single polyethylene (PE) jacket and the loose tu. Direct buried cable can be buried directly into the ground in a trench or using a vibratory plow. Aerial Cables are for outside i n s t a l l a t i o n o n p o l e s w h e r e consideration must be given to continual tension from the cable weight as well as wind and ice loads.

Read More

Get In Touch

Connect With Us

📧

Email

[email protected]

📱

Spain (Sales & Engineering HQ)

+34 910 257 483

📍

Headquarters & Manufacturing

Calle de la Innovación 22, 28043 Madrid, Spain